STUDIO setup

    1. Check the recommended distance of the Vantage from the bike. If it is either too close or too far, the Vantage will not be able to read the data coming from the Zin Tool. The recommended distance is 8 feet

    2. The height of the Vantage on the tripod from the ground could cause similar behavior. The recommended height is 3.5 feet

  • This could be caused by a height and/or distance discrepancy, as mentioned in the above question.

  • The success of the 2-step pedal spindle process is dependent the Vangtage successfully reading data coming from the three lowest markers on the harness, namely, the toe, heel, and ankle. If the Vantage cannot see these markers, there will be some challenges. Check the distance and height of your setup and verify that those markers are functioning

  • Inconsistent behavior of the devices could be the result of one of the following

    1. in your fit studio, If your Vantage is facing large windows that allow a lot of natural light to enter the room, this could cause some challenges. The Vantage will have difficulty determining the difference between the data coming from the LEDs and the natural light

    2. More answers coming soon…